Temart R-Hang Rotation Hanging System
Patented system for mounting framed art.
R-Hang is developed to fit the thin wooden frames commonly used for graphic art or photography.
The frame must be at least 10 mm wide and 10 mm thick. A frame fitted with R-Hanger hangs parallel to the wall, at a distance of only 3 mm.
- Dimensions R-Hang: 31 x 10 mm
- Max. load capacy of one R-Hang: 10 kg
- Each R-Hang comes with two flat head screws (2 x 10 and 3 x 30 mm).
Instructions for use
Step 1 - Mounting on the frame
1 a) Two R-hangers are screwed in parallel to frame's upper edge, as close as possible to the edge. Note that the R-hanger's long tongue must be mounted towards the frame, and a nylon washer placed between frame and R-hanger. Use screw matching frame profile's thickness. Frame must be at least 10 mm wide. Place plates at right angles to the frame and tighten screw gently so that R-hanger remains in position.
1 b) Screw in the other plates as far in as possible on the back of the artwork frame's outer sides, but no further in than 20 mm. Place these R-hangers too at right angles to the frame and tighten screws.
Step 2 - Wall mounting
2 a) Place frame's upper edge 40 mm beneath the final position. Ensure that picture's upper edge is horizontal and that the R-hanger is at right angles with the frame. Screw frame tight with the screws provided (3.5 x 16.0 mm). Ensure that screw is centred in the R-hanger's hole. Don't forget the nylon washer between the R-hanger and the wall. When both screws are tightened, the picture is hung, and both hands are free for the next step.
2 b) Turn frame 90 degrees clockwise.
2 c) Screw the right-hand R-hanger into the wall as described above. Ensure that the R-hanger is at right angles with the frame and that the screw is centred in the hole with the nylon washer between the R-hanger and the wall.
2 d) Turn picture 180 degrees and fasten the final R-hanger.
2 e) Screw the left-hand R-hanger into the wall as described above. Ensure that the R-hanger is at right angles with the frame and that the screw is centred in the hole with the nylon washer between the R-hanger and the wall.
2 f) Turn frame one final time 90 degrees clockwise so that all plates are hidden. If all R-hangers were at right angles with frame when they were screwed tight in the wall with centred screws, the frame will be hanging with a horizontal upper edge.
More products you might like
Temart M-Hang Support, Galvanized€14.04 €11.80
Temart Screws for Fix Plates, Galvanized€29.27 €24.60
Temart Frameplate M5 Thread, galvanised, 1 Set€20.35 €17.10
Temart Fix Plate "small", Stainless Steel, 1 Piece€1.29 €1.08
Temart T-Hang M4€7.62 €6.40
Temart Flexdrive M4 with Magnetic Sleeve€59.98 €50.40
Temart T-Hang M6 System, 1 Set€31.42 €26.40
Temart FHS 2 – Flexible Hanging System, 1 Set€43.67 €36.70
Temart HangClip (Temart MultiClip System), 1 Set€17.37 €14.60
Temart Flexhang M4, 1 Set€20.94 €17.60